Table of Contents
Advertisement
Océ | Printer Maintenance
5.
Monitor and replace any foam pads that are worn (significantly deformed) or
discolored. See Table 5-1, "Operator Maintenance Schedule Guidelines," on page 5-
2 for more details.
6.
Park the carriage using the Park Carriage menu.
Replacing Capping Station Pads
Follow these steps to replace the capping station pads:
1.
Soak new pads for at least 10 minutes in cleaning fluid (for 5500/6600-series inks)
or capping fluid (for 440-series inks) so they expand to seat correctly.
2.
Move the carriage using the Access Carriage menu to expose the capping station
surface.
3.
Open the right-side end cap doors.
4.
Remove and discard all used pads.
Note: If new pads are unavailable, remove the existing pads. Soak them in a
5.
Use a lint-free cloth saturated with cleaning fluid (for 5500/6600-series inks) or
capping fluid (for 440-series inks), and clean the capping station plate, especially the
indentions where the new pads will set (see Figure 5-7 on page 5-9).
6.
Squeeze most of the fluid from the new pads and install them into the indentations
in the capping station.
Note: Do not squeeze the pads dry. Leave some fluid so the pads remain
7.
Park the carriage using the Park Carriage menu.
5-10
container with cleaning fluid (for 5500/6600-series inks) or capping
fluid (for 440-series inks) for a few minutes and squeeze out the dirty
fluid. Repeat this process several times until the extracted fluid is
relatively clean.
moist.
Advertisement
Table of Contents
