Oce Arizona 600 User Manual page 144

Océ|Two-Sided Printing and Double Print
16. "ACCEPT" and using the +\- keys align the Print Point mark you made on the media
with the mark on the platen from above. When done, press "Accept" and the printer
will begin the printing process for the second side of the print.
8-Pass Line-Up
Double Print
1. Prior to printing the selected image, select "Double Print" from the "Operator/Print
Parameters" menu.
2. Begin printing. At the end of the job, the printer will complete drying the job and
rewind the media to approximately the beginning of the print.
You will then see:
Adjust Media Position
Accept or Cancel
3. Press ACCEPT. You then see:
Double Print Media Position
Adjust Media [+/-] --> done
Use the +/- buttons to align the print to the mark you made on the media. When
done, press ACCEPT and the printer begins double printing the selected job.
If you press CANCEL at the Adjust Media Position, Accept or Cancel message,
the printer begins double printing without allowing you to adjust the media
position. The printer rewinds the media slightly before the start of the original print.
The second print is likely to be offset from the first print. Pressing CANCEL is not
recommended.
D-4
4-Pass Line-Up