Figure 2-3 Supply Ink; Figure 2-4 Scanning The Ink Barcode - Oce Arizona 600 User Manual

1. Locate the container on the ink supply tray that requires replacement and remove the
cap and ink pick-up tube from the bottle (see Figure 2-3). Remove the empty bottle.
2. The barcode on each bottle must be scanned each time a new bottle of ink is added
to the printer (see Figure 2-4). For additional information about scanning the
barcode and ink bottle installation (see "Ink Bottle Installation" on page 4-28).
3. Remove the ink bottle cap and protective cover on the new ink supply bottle. Place
it on the ink supply tray and insert the ink pick-up tube and cap. It should be placed
loosely back on top of the bottle but not screwed down. If the cap seals too tightly,
the printer may not pump the ink to the reservoirs.
12/9/04

Figure 2-3 Supply Ink

Figure 2-4 Scanning the Ink Barcode

Ink Supply Changes
2-3