Table of Contents
Advertisement
Operator-Performed Maintenance
5.5
Waste Bottle Full
5.5.1
If the waste bottle is detected to be full, a warning message is displayed before the next print.
This message can be overridden up to five times before it becomes a hard error message. The
waste container must be emptied and disposed of in accordance with state and local laws or
in accordance with the MSDS sheets.
Cleaning Fluid/Capping Fluid Empty
5.5.2
If the cleaning fluid (for 5500/6600-series inks) or capping fluid (for 440-series inks) bottle
is detected to be empty, a warning message is displayed before the next print. This message
can be overridden up to five times before it becomes a hard error message.
Cleaning the Media Drive Roller
5.5.3
General Cleaning
The media drive roller should be wiped clean with a lint-free cloth and 91% or higher
isopropyl alcohol with every media change to maintain high feed accuracy and print quality.
Weekly, the media drive roller should be wiped clean with a sponge/scrubber and 91% or
higher isopropyl alcohol only to remove any accumulated paper dust or residue.
Additional Debris Removal
If too much media debris accumulates on the components, it can track back onto the media
and ruin prints. To keep your prints clean and free of debris, routine cleaning should be
done after each media roll change. This is especially important when using medias with
adhesive backing. They have a coated layer that comes off easily and accumulates on various
areas of the printer.
12/9/04
Figure 5-1 Cleaning the Media Drive Roller
Operator-Performed Maintenance
5-5
Advertisement
Table of Contents
