Table of Contents
Advertisement
Selecting the Media Type
The label on the end of the supply media box states the media type. If the correct media was
not selected during media load, follow these steps to select the media you loaded:
1.
Navigate to:
MAIN MENU
operator
2.
Press the ACCEPT button. You then see:
OPERATOR
print parameters
3.
Press the MENU button four times. You then see:
OPERATOR
media menu
4.
Press ACCEPT. You then see:
MEDIA MENU
Media table version: XXX
The media table contains the printer set-up values that are implemented when a
media is selected through the Media Type submenu. The version is updated by a
separate file that typically accompanies a new firmware version.
5.
Press ACCEPT. You then see:
MEDIA MENU
print side: first side
If you select the first side, go to step 9.
6.
Use the +/- buttons to select the second side. You then see:
MEDIA MENU
print side: second side
You only select this option if you are printing the second side of a double-sided
image.
7.
Press ACCEPT. You then see:
SECOND SIDE
supply core OD: (3.10" - 4.0")
Use the +/- buttons to enter the correct core diameter. The value is increased or
decreased in .01-inch increments. If you do not know the diameter, use a ruler and
measure the outside diameter of the core, and enter the value in this submenu.
12/9/04
Operator
4-21
Advertisement
Table of Contents
