Oce Arizona 600 User Manual page 87

2. Press ACCEPT. You then see:
INSTALL INK BOTTLE
color: [color]
Use the +/- button to select a color to install.
3. Select a color and press ACCEPT. You then see:
Scan barcode (Color)
Accept->Manual Entry
Scan the ink barcode found on the side of the bottle. Listen for the sound prompts;
single tone signifies that the barcode scan was successful whereas a double tone
signifies an unsuccessful scan. Check the control panel after a successful scan and
complete the ink bottle installation process. A barcode practice submenu is located
under the maintenance menu if you need to perfect the scan technique. The tip of
the barcode should run evenly across the width of the barcode including some
portion of the white space. Go to the next step to enter it manually when scanning
is unsuccessful.
4. Press ACCEPT. You then see:
BAR CODE
->->->->->->->->->->
For manual entry, use the +/- buttons to select one symbol or letter as shown below
the bar code on the ink bottle and press ACCEPT. Repeat this process until all
symbols and letters are entered.
If you enter an ink barcode from an unapproved ink or if no barcode information
is entered and you press ACCEPT or MENU, the following message is displayed:
WRONG INK TYPE
Press ACCEPT to continue
5. Press the ACCEPT or MENU button. The menu returns to step 3. You then see:
Scan barcode (color)
Accept->Manual Entry
The non-Océ ink barcode is 8 characters, beginning with the hyphen -YKT#J7R
12/9/04
Ink Menu
4-29