Table of Contents
Advertisement
CONTROL PANEL MESSAGE
ADD CYAN INK
then press ACCEPT
ADD MAGENTA INK
then press ACCEPT
ADD YELLOW INK
then press ACCEPT
ADD LIGHT CYAN INK
then press ACCEPT
ADD LIGHT MAGENTA INK
then press ACCEPT
SOLVENT LOW
System Messages
SYSTEM ERROR
[press ACCEPT to restart]
SYSTEM ERROR [press ACCEPT to
restart]
purge air pressure failure
SYSTEM ERROR [press ACCEPT to
restart]
carriage encoder error
12/9/04
EXPLANATION AND ACTION
Cyan ink is out. Replace the ink, and press
ACCEPT.
Magenta ink is out. Replace ink, and press
ACCEPT.
Yellow ink is out. Replace ink, and press
ACCEPT.
Light Cyan ink is out. Replace ink and then
press ACCEPT.
Light Magenta ink is out. Replace the ink,
and press ACCEPT.
Refill the cleaning fluid (for 5500/6600-series
inks) or capping fluid (for 440-series inks)
container.
Press ACCEPT for these types of mes-
sages. The printer performs a soft reboot.
Allow the printer to reboot and return to idle.
Do not power the printer Off and On to clear
these errors.
If the problem does not clear, call your
authorized service representative with the
details about what the printer was doing and
the exact error messages displayed on the
control panel.
If the error returns after you press ACCEPT
to restart the printer, call your authorized
service representative.
Perform the following step before you press
ACCEPT:
1. Clean and/or adjust the carriage cable
tension, as described in Chapter 5.
If the error returns after you press ACCEPT
to restart the printer, call your authorized
service representative.
System Errors
6-5
Advertisement
Table of Contents
