Automated Maintenance - Oce Arizona 600 User Manual

Océ | Printer Maintenance
Description
®
Plexiglas Windows
Print & Go Drive
Roller
Print Heads
Vacuum Platen
Ventilation and
Drying
Important: If 91% or higher isopropyl alcohol does not remove ink stains, use only the
approved cleaning fluid (for 5500/6600-series inks) or capping fluid (for
440-series inks) supplied with the printer in very small quantities. Do not
use cleaning fluid (for 5500/6600-series inks) or capping fluid (for 440-
series inks) on the Plexiglas windows. Always use protective gloves, eye
protectors, and a lint-free cloth when handling solvent-based solutions.

Automated Maintenance

5.4
The Arizona 600 printer firmware performs automated maintenance without direct
operator intervention when the printer is idle and while printing.
5-4
Procedure
Wipe clean with a lint-free cloth and 91% or
higher isopropyl alcohol only.
Wipe clean with a lint-free cloth and 91% or
higher isopropyl alcohol only (see Figure 3-18
on page 3-20).
Wipe clean with a sponge/scrubber and 91%
or higher isopropyl alcohol only (see Figure 3-
18 on page 3-20).
Clean the nozzle plates with a lint-free swab
and cleaning fluid (for 5500/6600-series inks)
or capping fluid (for 440-series inks) according
to the Print Head Maintenance and Nozzle
Recovery Procedures document "Printer
Maintenance" on page B-1.
Use the Operator/Maintenance Menu to purge
print heads. (Note: Media must be installed
when a purge is performed.)
Wipe clean with a lint-free cloth and 91% or
higher isopropyl alcohol or cleaning fluid
5500/6600-series inks) or capping fluid (for
440-series inks).
Cover the open ends with paper to improve
the vacuum when narrow media is in use.
Ensure that the airflow and ducting meet pub-
lished site survey requirements.
Frequency
As required
Every media
change
Weekly
Daily
As required
Every media
(for change
As required
Every 60 days