Table of Contents
Advertisement
If the printer determines that a full bottle has been used, the following message is displayed:
Expired barcode
press ACCEPT to continue
An expired bar code can occur from changing ink bottles without scanning a new bar code
or from additional ink being added to an installed bottle. Install a new bottle of ink and scan
its bar code.
Press the ACCEPT button. The menu returns to step 3 (see page 4-28). You then see:
Scan barcode (color)
Accept->Manual Entry
Configure I/0
0.6
The Arizona 600 printer has two types of data ports, Centronics
differential (LVD) SCSI-3. The correct configuration is typically selected by the installing
service engineer and should not require adjustment by the customer.
Parallel Port Configuration
0.6.1
Note: This port is only used by service engineers for downloading firmware.
LVD-SCSI-3 Port Configuration
0.6.2
The standard 68-pin LVD-SCSI-3 port connects the printer to the PosterShop RIP
platform via a standard 68-pin SCSI-3 data cable. The maximum length of this cable is 40
feet (12 meters).
Warning:
NEVER connect or disconnect SCSI cables with the printer or the host
PC powered ON.
Follow these steps to configure the SCSI-3 port:
1.
Navigate to:
MAIN MENU
CONFIGURE I/O
2.
Press the ACCEPT button. You then see:
CONFIGURE I/O
active: SCSI
12/9/04
Configure I/0
™
parallel and low-voltage
4-31
Advertisement
Table of Contents
