Table of Contents
Advertisement
Description
Carriage Rails
Cleaning Fluid (For
5500/6600-Series
Inks) or Capping
Fluid (For 440-Series
Inks)
Drip Roller
Encoder Strip
Ink Supply Bottles
Ink Waste Container
Interior and Exterior
Left and Right End
Caps
Media Drive Roller
Media Encoder Turn
Bar
12/9/04
Procedure
Wipe clean with a lint-free cloth and 91% or
higher isopropyl alcohol only. Use a lint-free
cloth saturated (but not dripping) with isopro-
pyl alcohol (see Figure 3-12 on page 3-10).
Refill the bottle when low or as indicated by
control panel messages. (See "Cleaning Fluid
or Capping Fluid Container and Waste Con-
tainer" on page 2-2.)
Wipe clean with a lint-free cloth and cleaning
fluid (for 5500/6600-series inks) or capping
fluid (for 440-series inks) (see Figure 3-12 on
page 3-10).
Wipe clean with a lint-free cloth and 91% or
higher isopropyl alcohol only. Take extra care
to not bend the strip when cleaning.
Replace when empty or as indicated by con-
trol panel messages. (See "Ink Supply
Changes" on page 2-2.)
Empty when control panel message indicates
the container is full. Follow ink MSDS require-
ments for disposal. (See "Cleaning Fluid or
Capping Fluid and Waste Bottles" on page 2-
2.)
Wipe surfaces clean with a lint-free cloth and
91% or higher isopropyl alcohol only.
All doors must be closed or secured at all
times to capture fumes and heat.
Wipe clean with a lint-free cloth and 91% or
higher isopropyl alcohol only.
Wipe clean with a sponge/scrubber and 91%
or higher isopropyl alcohol only. (See "Clean-
ing the Media Drive Roller" on page 5-5.)
Wipe the cylindrical-shaped steel bar clean
with a lint-free cloth and 91% or higher isopro-
pyl alcohol (see Figure 3-11 on page 3-9).
Operator Maintenance Schedule
Frequency
Once a week
As required
Daily
Once a month
As required
As required
Once a week
Always
Every media
change
Weekly
Every media
change
5-3
Advertisement
Table of Contents
