Oce Arizona 600 User Manual page 90

Océ | Control Panel
If the current setting is parallel, you will see:
CONFIGURE I/O
active: parallel
Use the +/- buttons to select SCSI.
3. Press ACCEPT. You then see:
SCSI PORT
SCSI address: (0 - 6)
This option specifies a SCSI address that identifies the printer to the host system.
Use the +/- buttons to select an address (0-6), as required.
4. Press ACCEPT. You then see:
SCSI Port
timeout XXX seconds
This option enables you to specify a time period in seconds (1-600) for the printer
to consider the job transfer complete, if an END OF PRINT command is not
received. The delay may need to be increased if the printer issues an error during
an image transfer. A typical error of this type may cause large blank areas (no data)
within the image. Increase this value by at least 60 seconds and try again. Use the
+ button to increment the timeout period.
The default setting is 60 seconds.
5. Press ACCEPT. You then see:
SCSI PORT
ultra SCSI: (on or off)
This parameter pertains to the SCSI card being used on the host PC. This
parameter is normally set to On so that the host PC and the printer can negotiate
the highest transfer speed. If the cable is too long, it can cause transfer problems.
This parameter should then be set to Off. Use the +/- buttons to select On or Off.
6. Press ACCEPT. You then see:
SCSI PORT
Interface cable detected: LVD or SE
7. Press ACCEPT. You then see:
CONFIGURE I/O
active: SCSI
4-32