Table of Contents
Advertisement
4.
Press ACCEPT. You then see:
REPRINTS
# reprints: XXX
Use the +/- buttons to select the total number of copies (1-300). If multiple copies
are selected, go to step 5. If one copy is selected, go to step 6.
5.
Press ACCEPT. You then see:
SPACING
vert=(0.00 - 0.20" to 8.98 - 9.18")
Use the +/- buttons to set the vertical spacing amount in inches between images.
6.
Press ACCEPT. The selected image begins printing.
If the media is narrower than the image, the following message is issued:
WARNING: Media too NARROW
CURRENT: xx", Required: xx
7.
Press CANCEL. You then see:
WARNING: Media too NARROW
Press - to cancel
8.
Press the - button to cancel the print.
Operator
0.4
The Operator menu provides access to the following submenus:
•
Print Parameters - Contains the job statistics (On or Off), minimal maintenance
during print (Off or On), and double print (Off or On) submenus (see Figure
A-2 on page A-3).
•
Test Prints - Contains the nozzle, configuration, color bars, and menu tree test
prints (see "Test Prints Menu" on page A-4).
•
Maintenance - Contains the access carriage, park carriage, high, low, long and
mini purge nozzles submenus. Also includes the spit heads, pump solvent, fill
reservoir, and barcode practice submenus (see "Maintenance Menu (Part 1)" on
page A-5 and "Maintenance Menu (Part 2)" on page A-6).
•
Media Menu - Contains menus for supply media selection and setup (see
"Media Menu" on page A-7).
•
About Printer - Enables you to view the total media printed in linear feet/meters,
firmware version, firmware build date/time, printer serial number, and boot
ROM version (see "About Printer Menu" on page A-8).
•
Units - Selects between English or metric units (see "Units Menu" on page A-9).
•
Set Clock - Sets up the printer date and time (see "Set Clock Menu" on page A-
10).
12/9/04
Operator
4-5
Advertisement
Table of Contents
