Table of Contents
Advertisement
Océ | Control Panel
Print Parameters
0.4.1
The Print Parameters menu sets up the basics of the print job, the controls for the image
margins, and the statistics for the job.
Follow these steps to use the Print Parameters menus:
1.
Navigate to:
MAIN MENU
operator
2.
Press the ACCEPT button. You then see:
OPERATOR
print parameter
3.
Press ACCEPT. You then see:
PRINT PARAMETERS
Statistics Menu: (on or off)
When the statistics menu is set to ON, the printer prints a set of job statistics in the
white space below the print area. Use the +/- buttons to turn statistics ON or OFF.
4.
Press ACCEPT. You then see:
PRINT PARAMETERS
minimal maintenance during print: ON
Use the +/- buttons to change the minimal maintenance during print setting to
OFF. The default setting is ON.
The minimal maintenance ON setting is the recommended setting and typically
gives the best results.
The minimal maintenance OFF setting uses different maintenance routines during
printing.
You may want to try minimal maintenance OFF if you are having excessive
overspray or nozzle dropout.
When disabled, the "[Min Maint: OFF]" message is included in the print statistics
line and is displayed on the operator panel.
5.
Press ACCEPT. You then see:
PRINT PARAMETERS
double print: OFF
Use the +/- buttons to change the double print setting to ON. The default setting
is OFF.
When the double print function is enabled (ON), the media is rewound and
reprinted following the initial printing of the image. Prior to the second print, the
4-6
Advertisement
Table of Contents
