5.
If not already open, gently open the top door completely, and pull the pinch roller
handle to disengage the rollers (see Figure 3-10).
Drip Roller
Rear
Carriage
Rail
Front
Carriage
Rail (Under
Aluminum
Strip)
Figure 3-10 Pinch Roller Handle
6.
From the front of the printer, push/pull the media towards the drive roll, making sure
it passes between the heat deflector and the drive roll (see Figure 3-11). Use the +/-
buttons to add more or less media during installation.
Heat Deflector
Drive Roll
Take-up Dancer
Figure 3-11 Feeding Media Over the Drive Roll
7.
Work the media over the front of the take-up dancer and around the back of the take-
up core (see Figure 3-12 on page 3-10). Before proceeding to step 8, walk behind the
12/9/04
Roll-to-Roll Media Installation
Pinch
Roller
Handle
3-9