Table of Contents
Advertisement
MAINTENANCE
fill reservoir
You will hear the waste pump running longer than the solvent pump.
Fill Reservoir
Follow these steps to manually fill a selected ink reservoir:
1.
Navigate to:
MAINTENANCE
pump solvent
2.
Press the MENU button. You then see:
MAINTENANCE
fill reservoir
3.
Press the ACCEPT button. You then see:
FILL RESERVOIR
[ color ]
Use the +/- buttons to select the required color to fill the ink reservoir.
4.
Press ACCEPT. You then see:
FILLING [ color ]: XXX
press CANCEL to stop
The filling process automatically stops when the ink reservoir is full.
If you cancel before the reservoir is full, you then see:
FILL RESERVOIR
[ color ]
Another color can be selected for filling.
5.
Press the CANCEL button twice. You then see:
MAINTENANCE
bar code practice
Bar Code Practice
The Bar Code Practice menu enables you to practice swiping an ink bottle barcode with the
wand attached to the printer. The wand must be held at a certain angle and moved side-to-
side over the barcode at a consistent speed. Listen for the audio beep confirmation from the
control panel. One beep is a positive read. Two beeps is a negative read. Bar code swiping
is required when a new or existing ink bottle is installed.
12/9/04
Operator
4-19
Advertisement
Table of Contents
