Table of Contents
Advertisement
Océ | Control Panel
To set up the Bar Code Practice menu, refer to the menu tree. Follow these steps to practice
scanning the bar code:
1.
Navigate to:
MAINTENANCE
fill reservoir
2.
Press the MENU button. You then see:
MAINTENANCE
barcode practice
3.
Press the ACCEPT button. You then see:
BARCODE PRACTICE
Press ACCEPT to Continue
4.
Press ACCEPT. You then see:
Scan the barcode
Accept->Manual Entry
5.
Scan the ink barcode found on the side of the bottle. Listen for the sound prompts;
single tone signifies that the barcode scan was successful whereas a double tone
signifies an unsuccessful scan. Check the control panel after a successful scan and
complete the ink bottle installation process. The tip of the barcode should run evenly
across the width of the barcode including some portion of the white space. Go to the
next step to enter it manually when scanning is unsuccessful.
6.
Press ACCEPT. You then see:
BAR CODE
->->->->->->->->->->
For manual entry, use the +/- buttons to select one symbol or letter as shown below
the bar code on the ink bottle and press ACCEPT. Repeat this process until all
symbols and letters are entered.
7.
Press the ACCEPT button, or press the CANCEL button. You then see:
OPERATOR
maintenance
Media Menu
0.4.4
The Media menu enables an operator to change the type of media selected during media
load or specify other media settings.
4-20
Advertisement
Table of Contents
