Table of Contents
Advertisement
18.
Press ACCEPT. You then see:
MEDIA MENU
hor. margins: (0.2" - 4.0")
Use the +/- buttons to adjust the horizontal margins.
19.
Press ACCEPT. You then see:
MEDIA MENU
ver. margins: (0.2" - 4.0")
Use the +/- buttons to adjust the vertical margins.
Press ACCEPT. You then see:
Sizing media
please wait
The printer sizes the media. If an error occurs, check the alignments along the
media path from the supply to the take-up core.
If no error occurs, you then see:
Stabilizing media
please wait
When stabilizing is complete, printer status information is displayed.
Media Types: Other
Selecting OTHER enables additional menus for manual media setup. When changing
values, holding the +/- buttons continuously increments or decrements the value repeatedly.
Follow the steps below for this media type option:
1.
You then see:
MEDIA MENU
Other
2.
Press the ACCEPT button. You then see:
MEDIA MENU
thickness: (2.00 - 30.00) mil
The range for thickness values is 2.00-30.00 mils. The media thickness is typically
on the media container label, if any. The media thickness changes by .05 mils.
Use the +/- buttons to increment or decrement the thickness setting.
3.
Press ACCEPT. You then see:
MEDIA MENU
takeup core OD: (3.10" - 4.00")
12/9/04
Roll-to-Roll Media Installation
3-13
Advertisement
Table of Contents
