Table of Contents
Advertisement
Cleaning the Capping Station
Follow these steps to clean the capping station plate:
1.
Move the carriage using the Access Carriage menu to expose the capping station
surface.
2.
Open the right-side end cap doors.
3.
Use a lint-free cloth saturated with cleaning solution/fluid, and clean the capping
station plate (see Figure 5-6).
4.
Monitor and replace any foam pads that are worn (significantly deformed) or
discolored. See Table 5-1, "Operator Maintenance Schedule Guidelines," on page 5-
2 for more details.
5.
Park the carriage using the Park Carriage menu.
Replacing Capping Station Pads
Follow these steps to replace the capping station pads:
1.
Soak new pads for at least 10 minutes in cleaning solution/fluid so they expand to
seat correctly.
2.
Move the carriage using the Access Carriage menu to expose the capping station
surface.
3.
Open the right-side end cap doors.
4.
Remove and discard all used pads.
5.
Use a lint-free cloth saturated with cleaning solution/fluid, and clean the capping
station plate, especially the indentions where the new pads will set (see Figure 5-6).
6.
Install the new pads, lightly pulling them toward the front of the printer so they seat
correctly.
7.
Park the carriage using the Park Carriage menu.
Maintenance Cloth Station
5.6
The maintenance cloth station (see Figure 5-7) is located in the left-side end cap. Two doors
provide access for replacing the blotting cloth. The cloth provides a purge area for the print
7/26/04
Maintenance Cloth Station
5-9
Advertisement
Table of Contents
