Oce Arizona 600 User Manual page 80

Océ | Control Panel
8. Press ACCEPT. You then see:
SECOND SIDE
condition media: OFF
Use the +/- buttons to turn media conditioning OFF/ON. The default value is
OFF.
Condition Media assists in accurate two-sided printing where the printed media
surface tension of the first side affects the printing of the second side. When set
ON, the printer advances the media the length of the print and rewinds to the
starting point.
9. Press ACCEPT. You then see:
MEDIA MENU
media name
Use the +/- buttons to select the media you have loaded.
If you select the Other media type, see "Media Type: Other" on page 4-23.
10. Press ACCEPT. You then see:
MEDIA MENU
takeup core OD: (3.10" - 4.0")
Use the +/- buttons to enter the correct core diameter. The value is increased or
decreased in .01-inch increments. If you do not know the diameter, use a ruler and
measure the outside diameter of the core, and enter the value in this submenu.
11. Press ACCEPT. You then see:
MEDIA MENU
conserve media: ON
Use the +/- buttons to turn media conservation ON/OFF. The default value is ON.
When set to ON, the printer rewinds the substrate to minimize waste before
printing the next image.
When set to OFF, the printer does not rewind the substrate before printing. This
setting should be used for media that is very thin or adhesive backed, which may
wrinkle during rewinding or become malformed by the heat required to dry the
inks.
12. Press ACCEPT. You then see:
MEDIA MENU
feed adjustment: +/- 0 - 30
Use the +/- buttons to set the feed adjustment from -30 to +30. The default value
is 0.
4-22