Oce Arizona 600 User Manual page 42

Océ | Media System
Use the +/- buttons to enter the correct core diameter. The value is increased or
decreased in .01-inch increments. If you do not know the diameter, use a ruler and
measure the outside diameter of the core, and enter the value in this submenu.
4. Press ACCEPT. You then see:
MEDIA MENU
supply core OD: (3.10" - 4.00")
Use the +/- buttons to enter the correct core diameter. The value is increased or
decreased in .01-inch increments. If you do not know the diameter, use a ruler and
measure the outside diameter of the core, and enter the value in this submenu.
5. Press ACCEPT. You then see:
MEDIA MENU
4-pass servo target temperature: 150F
The temperature increments or decrements by 1 degree. The maximum
temperature setting is 155
setting.
6. Press ACCEPT. You then see:
MEDIA MENU
8-pass servo target temperature: 135F
The temperature increments or decrements by 1 degree. The maximum
temperature setting is 155
setting.
7. Press ACCEPT. You then see:
MEDIA MENU
conserve media: ON
Use the +/- buttons to turn media conservation ON/OFF. The default value is ON.
When set to ON, the printer rewinds the substrate to minimize waste before
printing the next image.
When set to OFF, the printer does not rewind the substrate before printing. This
setting should be used for media that is very thin or adhesive backed, which may
wrinkle during rewinding or become malformed by the heat required to dry the
inks.
8. Press ACCEPT. You then see:
MEDIA MENU
feed adjustment: +/- 0 - 30
Use the +/- buttons to set the feed adjustment from -30 to +30. The default value
is 0.
3-14
º
F. Use the +/- buttons to change the temperature
º
F. Use the +/- buttons to change the temperature