Show Ssl Cachetimeout - Allied Telesis AT-9724TS Reference Manual

config ssl cachetimeout timeout
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To set the SSL cachetimeout for 7200 seconds:

show ssl cachetimeout

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To view the SSL cache timeout on the Switch:
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual
Used to configure the SSL cache timeout.
config ssl cachetimeout timeout <value 60-86400>
This command will set the time between a new key exchange between a client and a host using the SSL
function.A new SSL session is established every time the client and host go through a key exchange. Specifying a
longer timeout will allow the SSL session to reuse the master key on future connections with that particular
host, therefore speeding up the negotiation process.
timeout <value 60-86400> – Enter a timeout value between 60 and 86400 seconds to specify the total time an
SSL key exchange ID stays valid before the SSL module will require a new, full SSL negotiation for connection.
The default cache timeout is 600 seconds.
Only administrator-level users can issue this command.
AT-9724TS:4# config ssl cachetimeout timeout 7200
Command: config ssl cachetimeout timeout 7200
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
Used to show the SSL cache timeout.
show ssl cachetimeout
Entering this command will allow the user to view the SSL cache timeout currently implemented on the Switch.
None.
None.
AT-9724TS:4# show ssl cachetimeout
Command: show ssl cachetimeout
Cache timeout is 600 second(s).
A T - 9 7 2 4 T S : 4 #
164