Enable Mirror - Allied Telesis AT-9724TS Reference Manual

config mirror delete
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete the mirroring ports:

enable mirror

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable mirroring configurations:
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual
Used to delete a port mirroring configuration.
config mirror port <port> delete source port <portlist> [rx | tx | both]
This command is used to delete a previously entered port mirroring configuration.
port <port> – This specifies the Target port (the port where mirrored packets will be sent).The port is specified
by listing the lowest switch number and the beginning port number on that switch, separated by a colon. For
example, 1:3 specifies switch number 1, port 3. 2:4 specifies switch number 2, port 4.
delete source port – Adding this parameter will delete source ports according to ports entered using the
<portlist>.
<portlist> – This specifies a range of ports that will be mirrored.That is, the range of ports in which all traffic
will be copied and sent to the Target port.The port list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon.Then the highest switch number, and the highest
port number of the range (also separated by a colon) are specified.The beginning and end of the port list range
are separated by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4 specifies switch number 2, port
4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and switch 2, port 4 – in numerical order.
rx – Allows the mirroring of only packets received by (flowing into) the port or ports in the port list.
tx – Allows the mirroring of only packets sent to (flowing out of) the port or ports in the port list.
both – Mirrors all the packets received or sent by the port or ports in the port list.
Only administrator-level users can issue this command.
AT-9724TS:4# config mirror port 1:5 delete source port 1:1-
1:5 both
Command: config mirror port 1:5 delete source port 1:1-1:5
b o t h
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
Used to enable a previously entered port mirroring configuration.
enable mirror
This command, combined with the disable mirror command below, allows you to enter a port mirroring
configuration into the Switch, and then turn the port mirroring on and off without having to modify the port
mirroring configuration.
None.
None.
AT-9724TS:4# enable mirror
Command: enable mirror
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
101