Chapter 41 - Ospf Configuration Commands - Allied Telesis AT-9724TS Reference Manual

Chapter 41 - OSPF Configuration Commands

The OSPF configuration commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command
config ospf router_id
enable ospf
disable ospf
show ospf
create ospf area
delete ospf area
config ospf area
show ospf area
create ospf host_route
delete ospf host_route
config ospf host_route
show ospf host_route
create ospf aggregation
delete ospf aggregation
config ospf aggregation
show ospf aggregation
show ospf lsdb
show ospf neighbor
show ospf virtual_neighbor
config ospf ipif
config ospf all
show ospf ipif
show ospf all
create ospf virtual_link
config ospf virtual_link
delete ospf virtual_link
show ospf virtual_link
Each command is listed, in detail, in the following sections.
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual
Parameters
<ipaddr>
<area_id> type [normal | stub {stub_summary [enable | disable] | metric <value 0-65535>}]
<area_id>
<area_id> type [normal | stub {stub_summary [enable | disable] | metric <value 0-65535>}]
{<area_id>}
<ipaddr> {area <area_id> | metric <value 1-65535>}
<ipaddr>
<ipaddr> {area <area_id> | metric <value 1-65535>}
<ipaddr>
<area_id> <network_address> lsdb_type summary {advertise [enable | disable]}
<area_id> <network_address> lsdb_type summary
<area_id> <network_address> lsdb_type summary {advertise [enable | disable]}
<area_id>
{area <area_id> | advertise_router <ipaddr> | type [rtrlink | netlink | summary | assummary | asextlink]}
<ipaddr>
{<area_id> <neighbor_id>}
<ipif_name 12> {area <area_id> | priority <value> | hello_interval <sec 1-65535 > | dead_interval <sec 1-
65535> | authentication [none | simple <password 8> | md5 <key_id 1-255>] | metric <value 1-65535> state
[enable | disable]
{area <area_id> | priority <value> | hello_interval <1-65535 sec> | dead_interval <1-65535 sec> |
authentication [none | simple <password 8> | md5 <key_id 1-255>] | metric <value 1-65535> state [enable |
disable]
<ipif_name 12>
<area_id> <neighbor_id> {hello_interval <sec 1-65535> | dead_interval <sec 1-65535> | authentication [none
| simple <password 8> | md5 <key_id 1-255>]}
<area_id> <neighbor_id> {hello_interval <sec 1-65535> | dead_interval <sec 1-65535> | authentication [none
| simple <password 8> | md5 <key_id 1-255>]}
<area_id> <neighbor_id>
<area_id> <neighbor_id>
250