Chapter 30 - Arp Commands - Allied Telesis AT-9724TS Reference Manual

Chapter 30 - ARP Commands

The ARP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command
create arpentry
delete arpentry
show arpentry
config arp_aging time
clear arptable
Each command is listed, in detail, in the following sections.
create arpentry
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a static ARP entry for the IP address 10.48.74.121 and MAC address 00:50:BA:00:07:36:
delete arpentry
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete an entry of IP address 10.48.74.121 from the ARP table:
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual
Parameters
<ipaddr> <macaddr>
[<ipaddr> | all]
{ipif <ipif_name 12> | ipaddress <ipaddr> | static}
<value 0-65535>
Used to make a static entry into the ARP table.
create arpentry <ipaddr> <macaddr>
This command is used to enter an IP address and the corresponding MAC address into the Switch's ARP table.
<ipaddr> – The IP address of the end node or station.
<macaddr> – The MAC address corresponding to the IP address above.
Only administrator-level users can issue this command.
AT-9724TS:4# create arpentry 10.48.74.121 00-50-BA-00-07-36
Command: create arpentry 10.48.74.121 00-50-BA-00-07-36
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
Used to delete a static entry into the ARP table.
delete arpentry {<ipaddr> | all}
This command is used to delete a static ARP entry, made using the create arpentry command above, by
specifying either the IP address of the entry or all. Specifying all clears the Switch's ARP table.
<ipaddr> – The IP address of the end node or station.
all – Deletes all ARP entries.
Only administrator-level users can issue this command.
AT-9724TS:4# delete arpentry 10.48.74.121
Command: delete arpentry 10.48.74.121
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
210