Chapter 9 - Network Monitoring Commands - Allied Telesis AT-9724TS Reference Manual

Chapter 9 - Network Monitoring Commands

The network monitoring commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command
show packet ports
show error ports
show utilization
clear counters
clear log
show log
enable syslog
disable syslog
show syslog
create syslog host
config syslog host
config syslog host all
delete syslog host
show syslog host
Each command is listed, in detail, in the following sections.
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual
Parameters
<portlist>
<portlist>
[ports | cpu]
ports <portlist>
<ipaddr> {times <value 1-255>} {timeout <sec 1-99>}
index <value_list>
[<index 1-4> | all] {severity [informational | warning | all] | facility [local0 | local1 | local2 | local3 | local4 |
local5 | local6 | local7] | udp_port <udp_port_number> | ipaddress <ipaddr> | state [enable | disable]}
<index 1-4> {severity [informational | warning | all] | facility [local0 | local1 | local2 | local3 | local4 | local5 |
local6 | local7] | udp_port <udp_port_number> | ipaddress <ipaddr> | state [enable | disable]}
{severity [informational | warning | all] | facility [local0 | local1 | local2 | local3 | local4 | local5 | local6 | local7] |
udp_port <udp_port_number> | state [enable | disable]}
[<index 1-4> | all]
[<index 1-4>]
55