Chapter 18 - Igmp Commands - Allied Telesis AT-9724TS Reference Manual

Chapter 18 - IGMP Commands

The IGMP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command
config igmp
show igmp
show igmp group
Each command is listed, in detail, in the following sections.
config igmp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the IGMP for the IP interface System:
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual
Parameters
[ipif <ipif_name 12> | all] {version <value 1-2> | query_interval <sec 1-65535> | max_response_time <sec 1-
25> | robustness_variable <value 1-255> | last_member_query_interval <sec 1-25> | state [enable | disable]}
{ipif <ipif_name 12>}
{group <group>} {ipif <ipif_name 12>}
Used to configure IGMP on the Switch.
config igmp [ipif <ipif_name 12> | all] {version <value 1-2> | query_interval <sec 1-
65535> | max_response_time <sec 1-25> | robustness_variable <value 1-255> |
last_member_query_interval <sec 1-25> | state [enable | disable]}
This command allows you to configure IGMP on the Switch.
<ipif_name 12> – The name of the IP interface for which you want to configure IGMP.
version <value 1-2> – The IGMP version number.
query_interval <sec 1-65535> – The time in seconds between general query transmissions, in seconds.
max_response_time <sec 1-25> – Enter the maximum time in seconds that the Switch will wait for reports from
members.
robustness_variable <value 1-255> – This value states the permitted packet loss that guarantees IGMP.
last_member_query_interval <value 1-25> – The Max Response Time inserted into Group-Specific Queries sent
in response to Leave Group messages, and is also the amount of time between Group-Specific Query messages.
The default is 1 second
state [enable | disable] – Enables or disables IGMP for the specified IP interface.
Only administrator-level users can issue this command.
AT-9724TS:4# config igmp all version 1 state enable
Command: config igmp all version 1 state enable
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
121