Chapter 29 - Time And Sntp Commands - Allied Telesis AT-9724TS Reference Manual

Chapter 29 - Time and SNTP Commands

The Simple Network Time Protocol (SNTP) {an adaptation of the Network Time Protocol (NPT)} commands in the Command Line Interface (CLI) are listed
(along with the appropriate parameters) in the following table.
Command
config sntp
show sntp
enable sntp
disable sntp
config time
config time_zone
config dst
show time
Each command is listed, in detail, in the following sections:
config sntp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure SNTP settings:
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual
Parameters
{primary <ipaddr> | secondary <ipaddr> | poll-interval <int 30-99999>}
<date ddmthyyyy > <time hh:mm:ss>
{operator [+ | -] | hour <gmt_hour 0-13> | min <minute 0-59>}
[disable | repeating {s_week <start_week 1-4,last> | s_day <start_day sun-sat>| s_mth <start_mth 1-12> |
s_time <start_time hh:mm> | e_week <end_week 1-4,last> | e-day <end_day sun-sat> | e_mth <end_mth 1-
12> | e_time <end_time hh:mm> | offset [30 | 60 | 90 | 120]} | annual {s_date <start_date 1-31> | s_mth
<start_mth 1-12> | s_time <start_time hh:mm> | e_date <end_date 1-31> | e_mth <end_mth 1-12> | e_time
<end_time hh:mm> | offset [30 | 60 | 90 | 120]}]
Used to setup SNTP service.
config sntp {primary <ipaddr> | secondary <ipaddr> | poll-interval <int 30-99999>}
Use this command to configure SNTP service from an NTP server. SNTP must be enabled for this command to
function (See enable sntp).
primary – This is the primary server the SNTP information will be taken from.
<ipaddr> – The IP address of the primary server.
secondary – This is the secondary server the SNTP information will be taken from in the event the primary
server is unavailable.
<ipaddr> – The IP address for the secondary server.
poll-interval <int 30-99999> – This is the interval between requests for updated SNTP information.The polling
interval ranges from 30 to 99,999 seconds.
Only administrator-level users can issue this command. SNTP service must be enabled for this command to
function (enable service must be enabled for this command to function (enable sntp).
AT-9724TS:4# config sntp primary 10.1.1.1 secondary
10.1.1.2 poll-interval 30
Command: config sntp primary 10.1.1.1 secondary
10.1.1.2 poll-interval 30
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
205