Disable Syslog; Show Syslog; Create Syslog Host - Allied Telesis AT-9724TS Reference Manual

disable syslog

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable the syslog function on the Switch:

show syslog

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the current status of the syslog function:

create syslog host

Purpose
Syntax
Description
Parameters
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual
Used to disable the system log function on the Switch.
disable syslog
The disable syslog command disables the system log function on the Switch.After disabling, Syslog entries
will no longer be sent to a remote host.
None.
Only administrator-level users can issue this command.
AT-9724TS:4# disable syslog
Command: disable syslog
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
Used to display the syslog protocol status as enabled or disabled.
show syslog
The show syslog command displays the syslog status as enabled or disabled.
None.
None.
AT-9724TS:4# show syslog
Command: show syslog
Syslog Global State:
E n a b l e d .
A T - 9 7 2 4 T S : 4 #
Used to create a new syslog host.
show create syslog host [<index 1-4>] {severity [informational | warning | all] facility
[local0 | local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port<int> | ipaddress
<ipaddr> | state [enable | disable]
The create syslog host command is used to create a new syslog host.
<index 1-4> – Specifies that the command will be applied to an index of hosts.There are four available indexes,
numbered 1 through 4.
severity – Severity level indicator.These are described in the following:
Bold font indicates that the corresponding severity level is currently supported on the Switch.
Numerical Code
0
1
2
3
Severity
Emergency: system is unusable
Alert: action must be taken immediately
Critical: critical conditions
Error: error conditions
61