Disable Snmp Traps - Allied Telesis AT-9724TS Reference Manual

disable snmp traps

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To prevent SNMP traps from being sent from the Switch:
disable snmp authenticate_traps
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable the SNMP authentication trap support::
config snmp system_contact
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the Switch contact to "MIS Department II":
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual
Used to disable SNMP trap support on the Switch.
disable snmp traps
This command is used to disable SNMP trap support on the Switch.
None.
Only administrator-level users can issue this command.
AT-9724TS:4# disable snmp traps
Command: disable snmp traps
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
Used to disable SNMP authentication trap support.
disable snmp authenticate_traps
This command is used to disable SNMP authentication support on the Switch.
None.
Only administrator-level users can issue this command.
AT-9724TS:4# disable snmp authenticate_traps
Command: disable snmp authenticate_traps
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
Used to enter the name of a contact person who is responsible for the Switch.
config snmp system_contact{<sw_contact>}
The config snmp system_contact command is used to enter the name and/or other information to
identify a contact person who is responsible for the Switch.A maximum of 255 character can be used.
<sw_contact> – A maximum of 255 characters is allowed.A NULL string is accepted if there is no contact.
Only administrator-level users can issue this command.
AT-9724TS:4# config snmp system_contact richard
Command:config snmp system_contact richard
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
47