Config Firmware - Allied Telesis AT-9724TS Reference Manual

config firmware

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete a firmware from the Switch's memory:
Example usage:
To configure a firmware as the boot up runtime image firmware:
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual
To configure firmware currently in the Switch's NV-RAM.
config firmware image_id <int 1-2> {delete | boot_up]
This command allows the user to configure the dual image firmware on the Switch.This Switch allows the user
to hold two firmware versions in its memory, labeled as image_id 1 and 2. Using this command, the user may
delete a firmware or set it as the boot up firmware for the Switch. If the boot up firmware is not specified by
the user, image_id 1 will be the default boot up firmware.
<int 1-2> – Select the ID number of the firmware in the Switch's memory to be configured.
delete – Selecting this parameter, along with the image_id will delete this firmware from the Switch's memory.
boot_up – Selecting this parameter, along with the image_id will set this firmware as the default boot up
runtime image firmware upon the next reboot of the Switch.
Only administrator-level users can issue this command.
AT-9724TS:4# config firmware image_id 2 delete
Command: config firmware image_id 2 delete
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
AT-9724TS:4# config firmware image_id 2 boot_up
Command: config firmware image_id 2 boot_up
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
52