Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Allied Telesis AT-9812T V2
Summary of Contents for Allied Telesis AT-9812T V2
- Page 1 AT-9800 Series Switch Quick Install Guide AT-9812T V2 AT-9816GB V2...
- Page 2 Allied Telesis, Inc. reserves the right to make changes in specifications and other information in this document without prior written notice. The information provided herein is subject to change without notice. In no event shall Allied Telesis, Inc. be liable for any incidental, special, indirect, or consequential damages whatsoever, including but not limited to lost profits, arising out of or related to this manual or the information contained herein, even if Allied Telesis, Inc.
-
Page 3: Models Covered By This Guide
Quick Install Guide Models Covered By This Guide This Quick Install Guide includes information on the following models: ■ AT-9812T V2 ■ AT-9816GB V2 Package Contents The following items are included with each AT-9800 Series switch. Contact your sales representative if any items are damaged or missing. -
Page 4: Installing The Switch
AT-9800 Series Switch Installing the Switch This equipment must be earthed. Follow these steps to install the switch: Read the safety information For safety information, see the AT-9800 Series Safety and Statutory Information booklet. A copy of this booklet is supplied with each switch, and can also be found on the Documentation and Tools CD-ROM or at www.alliedtelesis.com/support/software. - Page 5 Quick Install Guide Figure 1: AT-9816GB front panel and rear panel with AC power inlet AT-9816GB V2 Layer 3 Fast Ethernet Switch 1000BASE-X GBIC PORT ACTIVITY LINK / FULL DUP ACTIVITY LINK / HALF DUP ACTIVITY GBIC GBIC ENABLED DISABLED FAULT RS-232 STATUS...
- Page 6 GBIC firmly into place. A range of GBICs have been tested and approved for use with AT-9800 Series switches. For more information, contact your authorised Allied Telesis distributor or reseller, or visit www.alliedtelesis.com. RX and TX terminal locations on SC fibre GBIC ports are the reverse of RX and TX terminal locations on fixed SC fibre ports.
-
Page 7: Configuring The Switch
Quick Install Guide Configuring the Switch Some configuration is necessary to enable the advanced switching capabilities of the switch. The switch can be configured via the Command Line Interface (CLI) or Graphical User Interface (GUI). Using the CLI to configure a switch Connect a terminal or PC to RS-232 (ASYN0) Using the supplied RS-232 DB9 straight-through cable, connect your terminal or PC to the RS-232 Terminal Port on the switch’s front panel. - Page 8 AT-9800 Series Switch Alternatively, type a question mark (?) at the end of a partially completed command to see a list of valid options. See the AT-9800 Series Switch AlliedWare™ Operating System Software Reference for more information on configuring the switch. Using the GUI to configure a switch This section describes how to establish a connection to the switch through the GUI, so you can configure the switch before installing it in your LAN.
-
Page 9: System Leds
Quick Install Guide System LEDs The following LEDs report operations and faults on AT-9800 Series switches (Table Table 1: System LEDs on AT-9800 Series switches State Function Green The switch is receiving power (Power) Fault The switch or management software is malfunctioning 1 Flash A switch fan has failed or is operating below the recommended speed... -
Page 10: Documentation And Tools Cd-Rom
AT-9800 Series Switch Documentation and Tools CD-ROM The Documentation and Tools CD-ROM bundled with each switch contains the complete Documentation Set for AT-9800 Series switches and their expansion options, as well as tools for managing the Switch. The CD-ROM includes: The AT-9800 Series Statutory and Safety Information booklet, which provides ■...
Need help?
Do you have a question about the AT-9812T V2 and is the answer not in the manual?
Questions and answers