Delete Iproute - Allied Telesis AT-9724TS Reference Manual

create iproute default
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To add the default static address 10.48.74.121, with a metric setting of 1, to the routing table:

delete iproute

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete a backup static address 10.48.75.121, mask 255.0.0.0 and gateway (ipaddr) entry of 10.1.1.254 from the routing table:
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual
Used to create IP route entries to the Switch's IP routing table.
create iproute default <ipaddr> {<metric>}
This command is used to remove a VRRP router running on a local device.
<metric> – Allows the entry of a routing protocol metric entry representing the number of routers between
the Switch and the IP address above.The default setting is 1.
Only administrator-level users can issue this command.
AT-9724TS:4# create iproute default 10.48.74.121 1
Command: create iproute default 10.48.74.121 1
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
Used to delete an IP route entry from the Switch's IP routing table.
delete iproute default <network_address> <ipaddr> [primary | backup]
This command will delete an existing entry from the Switch's IP routing table.
<network_address> – IP address and netmask of the IP interface that is the destination of the route.The address
and mask information can be specified using the traditional format (for example, 10.1.2.3/255.0.0.0 or in CIDR
format, 10.1.2.3/8).
<ipaddr> – The gateway IP address for the next hop router.
Only administrator-level users can issue this command.
AT-9724TS:4# delete iproute 10.48.74.121/8 10.1.1.254
Command: delete iproute 10.48.74.121/8 10.1.1.254
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
221