Show Log; Enable Syslog - Allied Telesis AT-9724TS Reference Manual

show log

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the Switch history log:

enable syslog

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the syslog function on the Switch:
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual
Used to display the Switch's history log.
show log {index <value_list>}
This command will display the contents of the Switch's history log.
index <value_list> – Enter a value that corresponds to an entry made in the log. Multiple entries may be made in
the form of x-x where x is the number of an entry in the log.The smallest number (and therefore the earlier
entry) will be first.
None.
AT-9724TS:4# show log index 1-4
Command: show log index 1-4
I n d e x D a t e T i m e
- - - - - - - - - - - - -
4 2 0 0 0 - 0 3 - 0 2 0 1 : 5 4 : 5 3
3 2 0 0 0 - 0 3 - 0 2 0 1 : 5 4 : 5 3
2 2 0 0 0 - 0 3 - 0 2 0 1 : 5 4 : 5 3
1 2 0 0 0 - 0 2 - 2 8 0 6 : 0 6 : 0 9
A T - 9 7 2 4 T S : 4 #
Used to enable the system log to be sent to a remote host.
enable syslog
The enable syslog command enables the system log to be sent to a remote host.
None.
Only administrator-level users can issue this command.
AT-9724TS:4# enable syslog
Command: enable syslog
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
Log Text
- - - - - - - -
Port 1:13 link up, 100Mbps FULL duplex
Spanning Tree Protocol is enabled
Unit 1, System started up
Spanning Tree Protocol is disabled
60