Show Packet Ports - Allied Telesis AT-9724TS Reference Manual

show packet ports

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the packets analysis for port 7 of module 2:
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual
Used to display statistics about the packets sent and received by the Switch.
show packet ports <portlist>
This command is used to display statistics about packets sent and received by ports specified in the port list.
<portlist> – Specifies a range of ports to be displayed.The port list is specified by listing the lowest switch
number and the beginning port number on that switch, separated by a colon.Then the highest switch number,
and the highest port number of the range (also separated by a colon) are specified.The beginning and end of
the port list range are separated by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and switch 2, port 4 – in
numerical order.
None.
AT-9724TS:4# show packet port 2:7
Port number : 2:7
Frame Size Frame Counts
- - - - - - - - - - - - - - - - - - - - - -
6 4 3 2 7 5
6 5 - 1 2 7 7 5 5
1 2 8 - 2 5 5 3 1 6
2 5 6 - 5 1 1 1 4 5
5 1 2 - 1 0 2 3 1 5
1 0 2 4 - 1 5 1 8 0
Unicast RX 1 5 2
Multicast RX 5 5 7
Broadcast RX 3 6 8 6
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
F r a m e s / s e c
- - - - - - - - - -
1 0 RX Bytes
1 0 RX Frames
1
0 TX Bytes
0 TX Frames
0
1
2
1 6
Frame Type T o t a l
- - - - - - - - - - - - - - -
4 0 8 9 7 3 1 6 5 7
4 3 9 5 1 9
7 9 1 8 1 7 8
1 1 1 2
T o t a l / s e c
- - - - - - - - -
56