Config Gvrp; Enable Gvrp - Allied Telesis AT-9724TS Reference Manual

config gvrp

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To set the ingress checking status, the sending and receiving GVRP information:

enable gvrp

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the generic VLAN Registration Protocol (GVRP):
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual
Used to configure GVRP on the Switch.
config gvrp [<portlist> | all] {state [enable | disable] | ingress_checking [enable | disable] |
acceptable_frame [tagged_only | admit_all] | pvid <vlanid 1-4094>}
This command is used to configure the Group VLAN Registration Protocol on the Switch.You can configure
ingress checking, the sending and receiving of GVRP information, and the Port VLAN ID (PVID).
<portlist> – A range of ports to configure GVRP for.The port list is specified by listing the lowest switch
number and the beginning port number on that switch, separated by a colon.Then the highest switch number,
and the highest port number of the range (also separated by a colon) are specified.The beginning and end of
the port list range are separated by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and switch 2, port 4 – in
numerical order.
all – Specifies all of the ports on the Switch.
state [enable | disable] – Enables or disables GVRP for the ports specified in the port list.
ingress_checking [enable | disable] – Enables or disables ingress checking for the specified port list.
acceptable_frame [tagged_only | admit_all] – This parameter states the frame type that will be accepted by the
Switch for this function. tagged_only implies that only VLAN tagged frames will be accepted, while admit_all
implies tagged and untagged frames will be accepted by the Switch.
pvid – Specifies the default VLAN ID associated with the port.
Only administrator-level users can issue this command.
AT-9724TS:4# config gvrp 1:1-1:4 state enable
ingress_checking enable acceptable_frame tagged_only pvid 2
Command: config gvrp 1:1-1:4 state enable ingress_checking
enable acceptable_frame tagged_only pvid 2
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
Used to enable GVRP on the Switch.
enable gvrp
This command, along with disable gvrp below, is used to enable and disable GVRP globally on the Switch,
without changing the GVRP configuration on the Switch.
None.
Only administrator-level users can issue this command.
AT-9724TS:4# enable gvrp
Command: enable gvrp
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
107