Chapter 35 - Dns Relay Commands - Allied Telesis AT-9724TS Reference Manual

Chapter 35 - DNS Relay Commands

The DNS relay commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command
config dnsr
enable dnsr
disable dnsr
show dnsr
Each command is listed, in detail, in the following sections.
config dnsr
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To set IP address 10.43.21.12 of primary.
Example usage:
To add an entry domain name dns1, IP address 10.43.21.12 to DNS static table:
Example usage:
To delete an entry domain name dns1, IP address 10.43.21.12 from DNS static table:
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual
Parameters
{[primary | secondary] nameserver <ipaddr> | [add | delete] static <domain_name 32> <ipaddr>}
{cache | static}
{cache | static}
{static}
Used to configure the DNS relay function.
config dnsr {[primary | secondary] nameserver <ipaddr> | [add | delete] static
<domain_name 32> <ipaddr>}
This command is used to configure the DNS relay function on the Switch.
primary – Indicates that the IP address below is the address of the primary DNS server.
secondary – Indicates that the IP address below is the address of the secondary DNS server.
nameserver <ipaddr> – The IP address of the DNS nameserver.
<domain_name 32> – The domain name of the entry.
<ipaddr> – The IP address of the entry.
None.
AT-9724TS:4# config dnsr primary 10.43.21.12
Command: config dnsr primary 10.43.21.12
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
AT-9724TS:4# config dnsr add static dns1 10.43.21.12
Command: config dnsr add static dns1 10.43.21.12
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
AT-9724TS:4# config dnsr delete static dns1 10.43.21.12
Command: config dnsr delete static dns1 10.43.21.12
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
232