Chapter 4 - Basic Switch Commands - Allied Telesis AT-9724TS Reference Manual

Chapter 4 - Basic Switch Commands

The basic switch commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command
create account
config account
show account
delete account
show config
show session
show switch
show switch_mode
show device status
show serial_port
config serial_port
enable clipaging
disable clipaging
enable telnet
disable telnet
enable web
disable web
save
reboot
reset
login
logout
Each command is listed, in detail, in the following sections:
create account
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create an administrator-level user account with the username "Allied Telesyn".
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual
Parameters
[admin | user] <username 15>
<username 15>
<username 15>
[current_config | config_in_NVRAM]
{baud_rate [115200] auto_logout [never | 2_minutes | 5_minutes | 10_minutes | 15_minutes]}
<tcp_port_number 1-65535>
<tcp_port_number 1-65535>
[log | all]
{[config | system]}
Used to create user accounts
create [admin | user] <username>
The create account command is used to create user accounts that consist of a username of 1 to 15
characters and a password of 0 to 15 characters. Up to 8 user accounts can be created.
Admin <username>
User <username>
Only Administrator-level users can issue this command.
Usernames can be between 1 and 15 characters.
Passwords can be between 0 and 15 characters.
AT-9724TS:4# create account admin Allied Telesyn
Command: create account admin Allied Telesyn
Enter a case-sensitive new password:****
Enter the new password again for confirmation:****
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
16