Chapter 7 - Network Management (Snmp) Commands - Allied Telesis AT-9724TS Reference Manual

Chapter 7 - Network Management (SNMP) Commands

The network management commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
The AT-9724TS supports the Simple Network Management Protocol (SNMP) versions 1, 2c, and 3.You can specify which version of the SNMP you want to use to
monitor and control the Switch.The three versions of SNMP vary in the level of security provided between the management station and the network device.The
following table lists the security features of the three SNMP versions:
SNMP Version
v1
v2c
v3
v3
v3
Each command is listed, in detail, in the following sections.
Command
create snmp user
delete snmp user
show snmp user
create snmp view
delete snmp view
show snmp view
create snmp community
delete snmp community
show snmp community
config snmp engineID
show snmp engineID
create snmp group
delete snmp group
show snmp groups
create snmp host
delete snmp host
show snmp host
create trusted_host
delete trusted_host
show trusted_host
enable snmp traps
enable snmp authenticate_traps
show snmp traps
disable snmp traps
disable snmp authenticate_traps
config snmp system contact
config snmp system location
config snmp system name
enable rmon
disable rmon
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual
Authentication Method
Community String
Community String
Username
MD5 or SHA
MD5 DES or SHA DES
Parameters
create snmp user <SNMP_name 32> <groupname 32> {encrypted [by_password auth [md5 <auth_password
8-16> | sha <auth_password 8-20>] priv [none | des <priv_password 8-16>] | by_key auth [md5 <auth_key
32-32> | sha <auth_key 40-40>] priv [none | des <priv_key 32-32>]]}
<SNMP_name 32>
<view_name 32> <oid> view_type [included | excluded]
<view_name 32> [all | oid]
<view_name 32>
<community_string 32> view <view_name 32> [read_only | read_write]
<community_string 32>
<community_string 32>
<snmp_engineID>
<groupname 32> {v1 | v2c |v3 [noauth_nopriv | auth_nopriv | auth_priv ]} {read_view <view_name 32> |
write_view <view_name 32> | notify_view <view_name 32>}
<groupname 32>
<ipaddr> {v1 |v2c | v3 [noauth_nopriv | auth_nopriv | auth_priv]} <auth_string 32>
<ipaddr>
<ipaddr>
<ipaddr>
<ipaddr>
<ipaddr>
<sw_contact>
<sw_location>
<sw_name>
Description
Community String is used for authentication – NoAuthNoPriv
Community String is used for authentication – NoAuthNoPriv
Username is used for authentication – NoAuthNoPriv
Authentication is based on the HMAC-MD5 or HMAC-SHA
algorithms – AuthNoPriv
Authentication is based on the HMAC-MD5 or HMAC-SHA
algorithms – AuthPriv.
DES 56-bit encryption is added based on the CBC-DES (DES-56)
standard
33