Create Ipif - Allied Telesis AT-9724TS Reference Manual

create ipif

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create the primary IP interface, p1 on VLAN Trinity:
To create the secondary IP interface, s1 on VLAN Trinity:
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual
Used to create an IP interface on the Switch.
create ipif <ipif_name 12> <network_address> <vlan_name 32> {secondary | {state
[enable | disable]}
This command will create an IP interface.
<ipif_name 12> – The name for the IP interface to be created.The user may enter an alphanumeric string of up
to 12 characters to define the IP interface.
<network_address> – IP address and netmask of the IP interface to be created.The address and mask
information can be specified using the traditional format (for example, 10.1.2.3/255.0.0.0 or in CIDR format,
10.1.2.3/8).
<vlan_name 32> – The name of the VLAN that will be associated with the above IP interface.
secondary – Enter this parameter if this configured IP interface is to be a secondary IP interface of the VLAN
previously specified. secondary interfaces can only be configured if a primary interface is first configured.
state [enable | disable] – Allows you to enable or disable the IP interface.
Only administrator-level users can issue this command.
AT-9724TS:4# create ipif p1 ipaddress 10.1.1.1 Trinity
state enable
Command: create ipif p1 ipaddress 10.1.1.1 Trinity state
e n a b l e
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
AT-9724TS:4# create ipif p1 ipaddress 12.1.1.1 Trinity
secondary state enable
Command: create ipif p1 ipaddress 12.1.1.1 Trinity
secondary state enable
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
117