Chapter 39 - IP Multicasting Commands
The IP multicasting commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command
show ipmc cache
show ipmc
Each command is listed, in detail, in the following sections:
show ipmc cache
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the current IP multicast forwarding cache:
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual
Parameters
{group <group>} {ipaddress <network_address>}
{ipif <ipif_name 12> | protocol [inactive | dvmrp | pim}
Used to display the current IP multicast forwarding cache.
show ipmc cache {group <group>} {ipaddress <network_address>}
This command will display the current IP multicast forwarding cache.
group <group> – The multicast group IP address.
ipaddress <network_address> – The IP address and netmask of the source.The address and mask information can
be specified using the traditional format (for example, 10.1.2.3/255.0.0.0 or in CIDR format, 10.1.2.3/8).
None.
AT-9724TS:4# show ipmc cache
Command: show ipmc cache
M u l t i c a s t
Source Address/
G r o u p
N e t m a s k
- - - - - - - - -
- - - - - - - - - - - - - -
2 2 4 . 1 . 1 . 1
1 0 . 4 8 . 7 4 . 1 2 1 / 3 2
2 2 4 . 1 . 1 . 1
20.48.74.25 /32
Total Entries: 3
A T - 9 7 2 4 T S : 4 #
U p s t r e a m
E x p i r e
N e i g h b o r
T i m e
- - - - - - - -
- - - - - -
1 0 . 4 8 . 7 5 . 6 3
3 0
d v m r p
2 0 . 4 8 . 7 5 . 2 5
2 0
d v m r p
R o u t i n g
P r o t o c o l
- - - - - - - -
246