Chapter 36 - Rip Commands - Allied Telesis AT-9724TS Reference Manual

Chapter 36 - RIP Commands

The RIP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command
config rip
enable rip
disable rip
show rip
Each command is listed, in detail, in the following sections.
config rip
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To change the RIP receive mode for the IP interface System:
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual
Parameters
[ipif <ipif_name 12> | all] {authentication [enable <password 16> | disable] | tx_mode [disable | v1_only |
v1_compatible | v2_only] | rx_mode [v1_only | v2_only | v1_or_v2 | disable] state [enable | disable]}
ipif <ipif_name 12>
Used to configure RIP on the Switch.
config rip [ipif <ipif_name 12> | all] {authentication [enable <password 16> | disable] |
tx_mode [disable | v1_only | v1_compatible | v2_only] | rx_mode [v1_only | v2_only |
v1_or_v2 | disable] state [enable | disable]}
This command is used to configure RIP on the Switch.
<ipif_name 12> – The name of the IP interface.
all – To configure all RIP receiving mode for all IP interfaces.
authentication [enable | disable] – Enables or disables authentication for RIP on the Switch.
<password 16> – Allows the specification of a case-sensitive password.
tx_mode – Determines how received RIP packets will be interpreted – as RIP version V1 only,V2 Only, or V1
Compatible (V1 and V2).This entry specifies which version of the RIP protocol will be used to transfer RIP
packets.The disabled entry prevents the reception of RIP packets.
disable – Prevents the transmission of RIP packets.
v1_only – Specifies that only RIP v1 packets will be transmitted.
v1_compatible – Specifies that only RIP v1 compatible packets will be transmitted.
v2_only – Specifies that only RIP v2 packets will be transmitted.
rx_mode – Determines how received RIP packets will be interpreted – as RIP version V1 only,V2 Only, or V1 or
V2.This entry specifies which version of the RIP protocol will be used to receive RIP packets.The Disabled
entry prevents the reception of RIP packets.
v1_only – Specifies that only RIP v1 packets will be transmitted.
v2_only – Specifies that only RIP v2 packets will be transmitted.
v1_or_v2 – Specifies that only RIP v1 or v2 packets will be transmitted.
state [enable | disable] – Allows RIP to be enabled and disabled on the Switch.
Only administrator-level users can issue this command.
AT-9724TS:4# config rip ipif System rx_mode v1_only
Command: config rip ipif System rx_mode v1_only
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
236