Show Snmp Host - Allied Telesis AT-9724TS Reference Manual

show snmp host

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the currently configured SNMP hosts on the Switch:
create trusted_host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create the trusted host:
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual
Used to display the recipient of SNMP traps generated by the Switch's SNMP agent.
show snmp host {<ipaddr>}
The show snmp host command is used to display the IP addresses and configuration information of remote
SNMP managers that are designated as recipients of SNMP traps that are generated by the Switch's SNMP
agent
<ipaddr> – The IP address of a remote SNMP manager that will receive SNMP traps generated by the Switch's
SNMP agent.
None.
AT-9724TS:4# show snmp host
Command: show snmp host
SNMP Host Table
Host IP Address
- - - - - - - - - - - - - - -
1 0 . 4 8 . 7 6 . 2 3
1 0 . 4 8 . 7 4 . 1 0 0
Total Entries: 2
A T - 9 7 2 4 T S : 4 #
Used to create the trusted host.
create trusted_host <ipaddr>
The create trusted_host command creates the trusted host.The Switch allows you to specify up to four IP
addresses that are allowed to manage the Switch via in-band SNMP or TELNET based management software.
These IP addresses must be members of the Management VLAN. If no IP addresses are specified, then there is
nothing to prevent any IP address from accessing the Switch, provided the user knows the Username and
Password.
<ipaddr> – The IP address of the trusted host.
Only administrator-level users can issue this command.
AT-9724TS:4# create trusted_host 10.48.74.121
Command: create trusted_host 10.48.74.121
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
SNMP Version Community Name/
SNMPv3 User Name
- - - - - - - - - - - - - - - - - - - - - - - - - - - -
V 2 c p r i v a t e
V3 authpriv p u b l i c
44