Chapter 20 - Mac Notification Commands - Allied Telesis AT-9724TS Reference Manual

Chapter 20 - MAC Notification Commands

The MAC notification commands in the Command Line Interface (CLI) are listed, in the following table, along with their appropriate parameters.
Command
enable mac_notification
disable mac_notification
config mac_notification
[<portlist> | all] [enable | disable]
show mac_notification
show mac_notification ports
Each command is listed, in detail, in the following sections.
enable mac_notification
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable MAC notification without changing basic configuration:
disable mac_notification
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable MAC notification without changing basic configuration:
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch • Command Line Interface Reference Manual
Parameters
{interval <int 1-2147483647> | historysize <int 1-500>}
<portlist>
Used to enable global MAC address table notification on the Switch.
enable mac_notification
This command is used to enable MAC Address Notification without changing configuration.
None.
Only administrator-level users can issue this command.
AT-9724TS:4# enable mac_notification
Command: enable mac_notification
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
Used to disable global MAC address table notification on the Switch.
disable mac_notification
This command is used to disable MAC Address Notification without changing configuration.
None.
Only administrator-level users can issue this command.
AT-9724TS:4# disable mac_notification
Command: disable mac_notification
S u c c e s s .
A T - 9 7 2 4 T S : 4 #
131