Table of Contents
Advertisement
2 Installation
Installing the Unit
Safety Considerations
Environment
WARNING
Cleaning
WARNING
Power Module Location
28
This DC Power Analyzer is a Safety Class 1 instrument, which means
it has a protective earth terminal. That terminal must be connected to
earth ground through a power source equipped with a ground
receptacle.
Refer to the Safety Summary page at the beginning of this guide for
general safety information. Before installation or operation, check
the DC Power Analyzer and review this guide for safety warnings and
instructions. Safety warnings for specific procedures are located at
appropriate places throughout this Guide.
Do not operate the instrument in the presence of flammable gasses or fumes
The environmental conditions of the instrument are documented in
Appendix A. Basically, the instrument should only be operated
indoors in a controlled environment.
The dimensions of your instrument as well as an outline diagram are
given in Appendix A. Fans cool the DC Power Analyzer by drawing
air through the side and exhausting it out the opposite side and back.
The instrument must be installed in a location that allows sufficient
space at the sides and back of the unit for adequate air circulation.
SHOCK HAZARD To prevent electric shock, unplug the unit before cleaning.
Use a dry cloth or one slightly dampened with water to clean the
external case parts. Do not use detergent or chemical solvents. Do
not attempt to clean internally.
The location of the power modules inside the mainframe determines
their front panel output assignments. To view the module/output
assignments, turn the unit on, press the Settings key, then press
Properties. The power modules are listed under each output channel.
Outputs that are not connected to a power module will not be
displayed in the Meter view.
Model N6705 User's Guide
Advertisement
Table of Contents
