Agilent Technologies N6705 User Manual page 191

SCPI Command
[SOURce:]LIST:TOUTput (continued)
:EOSTep
[:DATA] <Bool> {,<Bool>}, (@chanlist)
:POINts? (@chanlist)
:VOLTage
[:LEVel] <NRf> {,<NRf>}, (@chanlist)
:POINts? (@chanlist)
[SOURce:]POWer
:LIMit <NRf+>, (@chanlist)
[SOURce:]RESistance
[:LEVel]
[:IMMediate][:AMPLitude] <NRf+>, (@chanlist)
:STATe <Bool>, (@chanlist)
[SOURce:]STEP
:TOUTput <Bool>, (@chanlist)
[SOURce:]VOLTage
[:LEVel]
[:IMMediate][:AMPLitude] <NRf+>, (@chanlist)
:TRIGgered [:AMPLitude] <NRf+>, (@chanlist)
:BWIDth DEFault | FAST1 | FAST2 | FAST3, (@chanlist)
:LIMit
[:POSitive]
[:IMMediate][:AMPLitude] <NRf+>, (@chanlist)
:COUPle <Bool>, (@chanlist)
:NEGative
[:IMMediate][:AMPLitude] <NRf+>, (@chanlist)
:MODE FIXed | STEP | LIST | ARB, (@chanlist)
:PROTection
[:LEVel] <NRf+>, (@chanlist)
:DELay[:TIME] <NRf+>, (@chanlist)
:REMote
[:POSitive][:LEVel] <NRf+>, (@chanlist)
:NEGative[:LEVel] <NRf+>, (@chanlist)
:RANGe <NRf+>, (@chanlist)
:SENSe
:SOURce INTernal | EXTernal, (@chanlist)
:SLEW
[:IMMediate] <NRf+> | INFinity, (@chanlist)
MAXimum <Bool>, (@chanlist)
STATus
:OPERation
[:EVENt]? (@chanlist)
:CONDition? (@chanlist)
:ENABle <NRf>, (@chanlist)
:NTRansition <NRf>, (@chanlist)
:PTRansition <NRf>, (@chanlist)
:PRESet
Model N6705 User's Guide
Description
Generate triggers at the End Of STep
Returns the number of EOST list points
Sets the voltage list
Returns the number of voltage list points
Sets the power limit on output channels
Sets the output resistance (only on N6781A)
Enables/disables output resistance programming (N6781A)
Generate a trigger output on the voltage or current step
Sets the output voltage
Sets the triggered output voltage
Sets the voltage bandwidth (only on N678xA SMU)
Sets the positive voltage limit (only on N678xA SMU)
Sets the voltage limit tracking state (only on N6784A)
Sets the negative voltage limit (only on N6784A)
Sets the voltage trigger mode
Sets the over-voltage protection level
Sets the over-voltage protection delay (only on N6783A)
Sets the positive remote OV protection level (only on N678xA SMU)
Sets the negative remote OV protection level (only on N6784A)
Sets the output voltage range
Sets the remote sense relays
Sets the output voltage slew rate
Enables/disables the maximum slew rate override
Returns the value of the operation event register
Returns the value of the operation condition register
Enables specific bits in the event register
Sets the negative transition filter
Sets the positive transition filter
Presets all enable and transition registers to power-on
SCPI Commands Appendix B
191