Table of Contents
Advertisement
4 Using the Measurement Functions
Knob:
1
Vertical Volts/Div
2
Vertical Offset
3
Trigger Level
4
Horizontal Time/Div
5
Horizontal Offset
6
Marker 1/Marker 2
126
Using the Waveform Display Knobs
1
2
Description:
Makes the waveform bigger or smaller vertically in relation to its ground
reference. Specified in volts/division or amps/division on the y axis. If the
vertical gain causes the trace to be out of view, arrow symbols
will indicate the direction of the trace.
Moves the ground reference of the trace up or down in relation to the
horizontal center line of the grid. The offset popup that
appears in the upper right corner of the display shows
how far the ground reference of the selected trace is above or below the
horizontal center line of the grid.
Positive values indicate that the center line is above the ground reference.
Negative values indicate that the center line is below the ground reference.
Moves the trigger level up and down when a voltage or current level is the
trigger source. The trigger level is identified by the
level is out of view, an arrow
Note that trigger levels are not available in Normal (interleaved) mode.
Push the Trigger Level knob to auto-scale the traces on the display.
Zooms in or out of the data so that you can view waveform details. The
numbers on the bottom of the display indicate the location of the data that is
being viewed relative to the entire data log.
Moves the grid area to the right or left along the logged data.
Moves the measurement markers right or left. Press Data Logger to display
the markers. Markers are displayed on the selected trace. Values at the
bottom of the display are referenced to the intersection of the markers. If a
marker is out of view, an arrow indicates the direction of the marker.
Push the Marker 1 or Marker 2 knobs to reset the
markers. When pushed, the following menu appears.
Push the Enter key to Reset the marker. Push Enter
again to undo the reset action. Scroll down and
select Marker options to access the Datalogger Marker Properties window.
Scroll down and select Jump to peak to move the marker to the peak
measurement point of the trace.
symbol. If the trigger
indicates the direction of the trigger level.
Model N6705 User's Guide
3
4
5
6
Advertisement
Table of Contents
