Table of Contents
Advertisement
Scope View
Press
Scope View
This key
toggles
between
standard and
marker views.
1
Trace Controls
2
Output Traces
3
Horizontal
Time-base
4
Scope Status
5
Data Bar
6
Trigger Level
7
Ground
8
Trigger Mode
9
Trigger Source
10
M1 Marker
11
M2 Marker
12
Intersect Point
13
Measurements
Model N6705 User's Guide
1
2
3
4
10
Identifies the voltage or current trace that will be displayed. Dashes (----) indicate that
the specified trace is turned off. Select the trace and press Enter to turn it on or off.
V1, V2, V3, and V4 indicate voltage traces. I1, I2, I3, and I4 indicate current traces.
P1 and P2 indicate power traces. Press Trigger Level knob to autoscale all traces.
Identifies the horizontal time-base settings. These can be adjusted using the front panel
Horizontal Time/Div and Offset knobs.
Indicates whether the scope is idle, running, or waiting for a trigger.
The highlighted area shows how much of the entire measurement is actually shown on
the display. Use the Horizontal Time/Div knob and Offset knob to adjust the display
Identifies the trigger level through which the waveform must pass before the scope will
trigger. This can be adjusted using the Trigger Level knob.
Identifies the ground reference level for the trace. This can be adjusted using the
Vertical Offset knob. The initial vertical offset of each trace is set to a different level to
prevent the traces from overlapping.
Identifies the trigger mode setting. This can be selected by pressing the Properties key.
Identifies the trigger source and trigger level. Voltage 1 indicates a voltage level on
output 1 is the trigger source (see #6).
Measurement Marker 1 enabled. Adjust using Marker 1 knob. Press knob to reset.
Measurement Marker 2 enabled. Adjust using Marker 2 knob. Press knob to reset.
Shows where the measurement markers intersect the waveform.
Shows the calculations of the waveform data between Marker 1 and Marker 2.
Standard View
Marker View
Quick Reference 1
5
6
7
8
9
11
12
13
19
Advertisement
Table of Contents
