Table of Contents
Advertisement
Power Module Installation
NOTE
CAUTION
NOTE
Model N6705 User's Guide
The information in this section applies if you have purchased an N6705
mainframe without the power modules installed, or if you are adding a power
module to the mainframe.
Turn the mainframe off and disconnect the power cord before installing or
removing power modules. Observe all standard electrostatic discharge
precautions before handling electronic components.
Tools required: T10 Torx driver;
Small flat-blade screwdriver
5.5 mm hex wrench
Firmware Note: Newer power modules can only be installed in
N6705 mainframes with the latest firmware. Refer to the "Updates"
section in the front of this manual for more information. If your
mainframe has the latest firmware version, install the power module.
If not, download and install the latest version firmware from the web.
Step 1. Remove the top and bottom covers.
Loosen the thumb-screws to remove the covers. Turn the unit upside-
down to remove the bottom cover.
Step 2. Place the power modules in the mainframe
Align the power module over the pins and gently push it down onto
the connector. Install the screws at each end of the power module.
2
1
3
4
If you are installing a double-wide power module, you must first remove the
center deflector. Use a T10 Torx to remove the top deflector; use a 5.5 mm hex
to remove the bottom deflector. Install the deflector in the storage location on
the opposite end of the module. Connect the power module to output 1 or
output 3 only.
Installation 2
2
1
3
4
29
Advertisement
Table of Contents
