Table of Contents
Advertisement
1 Quick Reference
Data Logger
NOTE
Press
Data Logger
This key
toggles
between
standard and
marker views
1
Trace Controls
2
Output Traces
3
Status
4
Filename
5
Data Bar &
Time Elapsed
6
Time base
Information
7
Trigger
8
M1 Marker
9
M2 Marker
10
Intersect Point
11
Measurements
20
Option 055 deletes the Data Logger function on Model N6705.
1
2
3
4
8
Identifies the voltage or current trace that will be displayed. Dashes (----) indicate that
the specified trace is turned off. Select the trace and press Enter to turn it on or off.
Voltage, current, or power traces. Voltage traces V1,V2, V3 and V4 shown.
Press Trigger Level knob to autoscale all traces.
Indicates whether the Data Logger is logging data, done logging, or is empty.
Indicate the file to which the data is being logged.
Displays the progress of the data logger. The yellow bar indicates the visible data.
Numbers to the right indicate time elapsed/total duration.
Displays the time remaining before the trigger point; the time at the center line of the
grid in relation to trigger point; and the time elapsed since the trigger.
Identifies the trigger source and trigger offset. The trigger offset is specified in % of the
total duration, but shown in seconds on the display.
Measurement Marker 1 enabled. Adjust using Marker 1 knob. Press knob to reset.
Measurement Marker 2 enabled. Adjust using Marker 2 knob. Press knob to reset.
Shows where the measurement markers intersect the waveform.
Shows the calculations of the waveform data between Marker 1 and Marker 2.
Standard View
Marker View
Model N6705 User's Guide
5
6
7
9
10
11
Advertisement
Table of Contents
