Table of Contents
Advertisement
Using the keypad
The frequency can be set directly via numeral keys on the
microphone.
z Push [VFO/LOCK] to select the VFO mode, if
ENT
necessary.
C
x Push [
C(T-OFF)] to activate the keypad for
ENT
digit input.
c Push 6 keys to input a frequency.
• When a digit is mistakenly input, push [
to clear the input, then repeat input from the 1st digit.
• Pushing [
A(MW)] clears input digits and retrieves
CLR
the frequency.
[EXAMPLE]: Setting frequency to 145.3625 MHz.
Push
Push
Push
Push
Tuning step selection
Tuning steps are the minimum frequency change increments
when you rotate [DIAL] or push [Y]/[Z] on the microphone.
Independent tuning steps for each frequency band can be
set for your convenience. The following tuning steps are avail-
able.
• 5 kHz*
• 15 kHz* • 20 kHz
C(T-OFF)]
• 100 kHz • 125 kHz
ENT
*Not selectable in 900 MHz band.
NOTE: For convenience, select a tuning step that matches
the frequency intervals of repeaters in your area.
q Enter "TS" in MENU screen.
MENU
(Push [MENU
• Push [VFO/MHz] to select the VFO mode, if necessary.
[MENU
[DIAL]
w Rotate [DIAL] to select the desired tuning step.
e Push [MENU
BASIC OPERATION
†
• 6.25 kHz* • 8.33 kHz
• 10 kHz
• 25 kHz
• 30 kHz
• 200 kHz
†
Appears for VHF air band only.
TS
]), (Rotate [DIAL], then push [
]
[
]
] to exit the set mode.
2
1
2
3
4
5
• 12.5 kHz
6
• 50 kHz
7
8
9
10
11
](MONI).)
12
13
14
15
16
17
18
19
15
Advertisement
Table of Contents
